Dr U sputtered film is costly and unpredictable. The sputtered layer is adversely affected with each annealing, etching, and drying stage; this causes the film to become brittle, inflexible, and has a negative affect on adhesion, (substrate lock-out). Measurements taken after each stage of processing, show the impact of repeated heating, cooling and handling. In addition, there has been lot to lot variation in the supplied material that has negatively impacted the performance of applied films. The Acheson alternative provides consistent and reliable results that you can depend upon.
Dr U Sputtering Film is one of the most common and widely used technologies for thin film manufacturing. Quality of deposited films, however, not only depends on process and equipment parameters (such as vacuum conditions, temperature or equipment design) but also on the configuration and characteristics of the targets and the critical raw materials used for sputtering. In fact, target properties such as purity, density, shape, grain size and distribution or manufacturing process, directly affect the microstructure at the atomic level of the sputtered film.
Please contact us at our email: hma@umgchk.com
Mr. Chiu
Telephone: 852-69362679
Fax: 852-36781927
China call :86-755-25997821
